L298N controller

[system]

Not sure it's fried yet, it just did some small movement plus the LEDs are coming on and off OK.

Looking at the pic here:

http://www.google.com/imgres?q=L298N+Stepper+Motor+Driver+Controller+Board+for+Arduino&um=1&hl=en&client=safari&sa=N&tbo=d&rls=en&biw=973&bih=680&tbm=isch&tbnid=VZD3tXby8PUlIM:&imgrefurl=http://dx.com/p/l298n-stepper-motor-driver-controller-board-for-arduino-120542&docid=baNjhY4l-J55nM&imgurl=http://img.dxcdn.com/productimages/sku_120542_1.jpg&w=600&h=600&ei=6EOxUJq4HaiN4gTO6YD4CQ&zoom=1&iact=hc&vpx=4&vpy=134&dur=713&hovh=225&hovw=225&tx=102&ty=128&sig=117348941556890433591&page=1&tbnh=135&tbnw=127&start=0&ndsp=20&ved=1t:429,r:0,s:0,i:87

Those yellow pins have been described except the 5v, which goes to the Arduino + the GND which also goes to the Arduino, no other power source. Motor A/B of the blue pins are connected to the motors. The red wire is the one nearest the letter "M" in each case.