lilypad burn bootloader

Other Hardware General Electronics
1

Image: http://i.imgur.com/F2S9Oxm.jpg

I soldered 6 pins to my lilypad and connected it to my usbTinyISP.
When i use my ISP to burn the bootloader on my arduino Uno it works just fine, but when i try to do it on my lilypad i got this message:

avrdude: initialization failed, rc=-1
         Double check connections and try again, or use -F to override
         this check.

What is happening?

This is my configurations:
http://s11.postimg.org/btwwyr7xf/cen2.png

Thanks for your time :slight_smile:

DSC_0102.jpg
DSC_0102.jpg1944×1746 992 KB

2

anyone :frowning:

3

The red lead of the cable goes to the pin 1 end of the ICSP connector. I can't see a 1 on the board in that picture, perhaps you need to turn it around.

4

CrossRoads:
The red lead of the cable goes to the pin 1 end of the ICSP connector. I can't see a 1 on the board in that picture, perhaps you need to turn it around.

I have it on the right position, i tried to find out the + and - with my multimeter so i have sure it's right positioned.
I don't know about it, it might not work on this lilypad.
Btw, i want to solder that IC on a PCB, do i need components (capacitors for example) to make it able to be configured by a FTDI? And what about an ISP, it is right strait to the pins?