I have a conveyor system run by a 12 V brushed geared motor controlled by a L298 driver. Two limit switches at either end of the conveyor frame notify the Arduino Uno about the positions so the motor can reverse itself to alter direction. The driver is controlled by the Uno as well. However when the…

Limit switch self triggering when L298 driver is used with motor

wildbill November 26, 2017, 1:00pm 2

Do you have pull up (or pull down) resistors in place?

Topic		Replies	Views
Noise on limit switch inputs when my DC motor powersupply is on Motors, Mechanics, Power and CNC	3	2370	May 6, 2021
EMF from L298N triggering button? General Guidance	5	1180	May 5, 2021
Limit switch preventing Arduino 5V signal General Electronics	7	4039	May 6, 2021
Problema motore DC e L298 Hardware	6	2454	May 7, 2021
Interrupt triggering without cause Programming	8	977	May 5, 2021