Linear Actuator run time

Projects General Guidance
8

Hi Tom

Just looked over your post again, am I right in thinking then that the below code would run actuators 1 & 2 for 6 seconds but would on run actuators 3,4, 5 & 6 after actuators 1 & 2 have completed?.

digitalWrite(RELAY1,LOW); // Turns ON Relays 1
digitalWrite(RELAY2,LOW); // Turns ON Relays 2

delay(6000); // Wait 6 seconds

digitalWrite(RELAY1,HIGH); // Turns Relay Off
digitalWrite(RELAY2,HIGH); // Turns Relay Off

digitalWrite(RELAY3,LOW); // Turns ON Relays 3
digitalWrite(RELAY4,LOW); // Turns ON Relays 4
digitalWrite(RELAY5,LOW); // Turns ON Relays 5
digitalWrite(RELAY5,LOW); // Turns ON Relays 6

delay(3000); // Wait 3 seconds

digitalWrite(RELAY3,HIGH); // Turns Relay Off
digitalWrite(RELAY3,HIGH); // Turns Relay Off
digitalWrite(RELAY5,HIGH); // Turns Relay Off
digitalWrite(RELAY6,HIGH); // Turns Relay Off

Thanks
Andy