Hello folks, I have the majority of the code written that is needed for my project (reading earth magnetic values utilizing the LIS2MDL module). Backstory: I'll be using this as a magnetometer for subsurface surveying of our farm land, this device will be attached to the rear of our UTV in an elect…

LIS2MDL code help request

anon73444976 November 23, 2021, 6:19pm 6

You have a pull-down resistor on the pin, don't you?

Topic		Replies	Views
connecting LIS302DL motion sensor over SPI Interfacing	10	3355	May 6, 2021
Sensor magnético y Arduino. Hardware	26	6672	May 7, 2021
LIS3MDL Problems with magnetometer values Sensors	6	3818	May 6, 2021
Motor not listening to button Programming	25	1661	May 5, 2021
Switch Troubleshooting	14	15071	May 6, 2021