Here is a photo of the breadboard and the Arduino uno that I got from a kit.
EDIT: The small purple board on the bottom left in the BMP 280, the one to the right of that is the MPU6050 and further to the right is the SD card reader. The MPU6050 is connected to Analog 4 and 5 for the SDA and SCL pins whilst the BMP280 is connected to the SCL and SDA pins on the top right of the Uno. The chip select pin for the SD card reader is on pin 4. The SD card reader and the MPU6050 are connected to the 5V power each and the BMP 280 is connected to 3.3V. the Piezo Speaker, or buzzer, is connected to pin 7 and the red and green LED are connected to pins 8 and 9 respectively. 220 ohms resistors are being used to prevent the lights from going Boom (Or arguably less cool, Sizzle).