Hi, I got these situation, I conect my arduino to an optoacoplator, by using PWM, I'll show you the code I'm using, but the strange thing is when I measure the voltage between pwm pin and gnd it is 1,64V when the pwm is at 100%, shouldnt it be at 5V? #define MOTOR 11 #define RECARGA 3 int POT; i…

LOW Voltage on PWM

joamanya September 4, 2012, 7:31pm 5

If I takes out the acopaltor I recive 5V...

Topic		Replies	Views
Arduino with Optocoupler Interfacing	16	6779	May 6, 2021
0-10V PWM (2 Solution) General Electronics	20	17551	May 6, 2021
arduino optocoupler pwm feed General Electronics	10	4909	May 6, 2021
voltages and pins and optoisolators General Electronics	19	4698	May 6, 2021
Using arduino as a on/off switch for another 5volt system. Motors, Mechanics, Power and CNC	6	1418	May 6, 2021