#include <VarSpeedServo.h> VarSpeedServo myservo; const int servoPin = 9; const int sensorPin = 2; volatile int pos; void setup() { // put your setup code here, to run once: myservo.attach(servoPin); if(pos = 0) { myservo.write(0,255,true); pos = 0; } else myservo.write(90,255,true) pos …

Magnet sensor sweep code

clarkkent156 October 3, 2021, 4:39pm 14

is this sketch useless then? thx for your help.

Topic		Replies	Views
servo sweep problem Interfacing	10	7536	May 6, 2021
error message when trying to compile #include VarSpeedServo and bare minimum Programming	9	2846	May 5, 2021
Help using VarSpeedServo Programming	6	6915	May 6, 2021
Problema con librería VarSpeedServo Hardware	1	1866	May 7, 2021
Servo Motors not responsive Troubleshooting	4	926	May 6, 2021