I have a MKR Wifi 1010 board. I am trying to figure out the right value of a resistor as a current limiter for a typical 2V red LED that can draw a maximum of 20mA. I did some testing and without a current limiting resister, it seems the MKR Wifi 1010 will only let 7mA flow. I see a note in the fu…

When I first aquired my mkr wifi1010 I ran across this post discussing the "drive strength" of the pins on the samD boards. Apparently there is a bit in a register that sets the drive strength of the pins to be either 7mA or ~ 2.5mA depending on whether it is set or not. By default it is set to th…

Max Current for Digital Pins: Is it limited by the board?

Official Hardware MKR Family MKR WiFi 1010

LarryD September 8, 2021, 12:51am 6

BTW
What was the actual voltage drop on the LED when you measure it ?

Topic		Replies	Views
Confusing about maximal current per Pin General Electronics	8	3230	May 6, 2021
Max High Pins LEDs and Multiplexing	12	6579	May 6, 2021
Do I need a resistor on a 40 mA pin when all I need is 40 mA? LEDs and Multiplexing	26	9612	May 6, 2021
Voltage divider and old post. General Electronics	7	2892	May 6, 2021
Arduino Mega - LED limitations? Interfacing	3	2622	May 6, 2021

Max Current for Digital Pins: Is it limited by the board?

Related topics