Not on an arduino project, but I would like some help. I have a project with a 12Mhz crystal. It is connected to two pins of the PIC and two capacitors going to +5v. I have a handhelp scope (Jaycar) but am not sure how to get an output of the frequency. I believe it is the input to the crystal a…

Measuring crystal frequency - HELP!

mauried March 30, 2014, 9:56pm 9

The parallel resistor is normally in the PIC or AVR.
Without it , the oscillator wont run at all.

Topic		Replies	Views
Arduino as a frequency meter (counter) Interfacing	4	5497	May 6, 2021
reading crystal oscil using Arduino Duemilanove Interfacing	7	2260	May 6, 2021
Mystery Component Interfacing	15	3975	May 6, 2021
Choosing capacitor for crystal General Electronics	6	3270	May 6, 2021
Arduino and Crystals. Programming	3	1251	May 5, 2021