Hello ! i wanted to use a standard PCB on top of a Mega using simple male headers, but realized that the pins 8 to 13, GND and AREF did not follow the spacing of the other headers. any workaround to this problem ? what i've been thinking so far : unsoldering header 8 to 13 and AREF and wiring t…

Mega and standard PCB

hammy April 14, 2018, 8:21pm 6

You can get breakout prototype shields for the mega , build your circuit on one of those ?

Or ...

As suggested a board on one half of the mega , with flying leads , if needed to any pins on the other half ?

Topic		Replies	Views
Easy way of off-setting the digital output pins Development	13	3811	May 6, 2021
LAY-OUT OF THE In-Out PINS Suggestions for the Arduino Project	11	6413	May 6, 2021
Incorporating an Arduino Mega 2560 into finished project? General Guidance	9	3344	May 5, 2021
proto for 2560 How to get it wrong - twice Hardware Development	6	4890	May 6, 2021
pin 7,8 irregular offset Suggestions for the Arduino Project	11	12148	May 6, 2021