Hi all I've set up a 'positioner' with 3 axis, stepper-motors, motordrivers and an Arduino Mega to control it all. I've just tested the setup to see if the parts works together. I figure, that I'm going to involve an unknown set of sensors and buttons too, but realize that there'll be a lot of .. '…

Motorcontrolling through interrupts?

Grumpy_Mike April 19, 2012, 3:46pm 2

Yes this is the proper way to control a stepping motors. Using delay() is just for demos.

Topic		Replies	Views
Stepper Motor control 'delay()' problem Troubleshooting	4	3018	May 6, 2021
control the stepper motor Programming	8	3266	May 5, 2021
control stepper motor Motors, Mechanics, Power and CNC	15	4287	May 6, 2021
Efficient code for stepper motor control? Interfacing	4	3072	May 6, 2021
Control motor Paso a Paso con Interrupciones(velocidad mucho más rápida) Español	1	2201	May 6, 2021