Moveing servo motors wirelessly

i am using 2 arduino uno and 433MHz Rf module i’m trying to move two servo motors separately by changing potentiometer value.

But my code move the servo’s together . I want when i change the first potentiometer value the first servo move and when i change the second thee second servo move.

This is my Transmitter Code:

//Transmitter Code
#include <RCSwitch.h>

RCSwitch myswitch = RCSwitch();

int pot = A0;
int pot1 = A1;

void setup() {
Serial.begin(9600);

myswitch.enableTransmit(10);

}

void loop() {

int pott = analogRead(pot);
int pott1 = analogRead(pot1);

pott= map(pott,0,1024,1,180);
pott1= map(pott1,0,1024,1,180);

myswitch.send(pott, 10);
delay(200);
myswitch.send(pott1, 10);
delay(200);

}

And this is my Receiver code

//Receiver Code:
#include <RCSwitch.h>
#include <Servo.h>

Servo myservo;
Servo myservo1;

RCSwitch myswitch = RCSwitch();


void setup() {
myservo.attach(10);
myservo1.attach(11);

Serial.begin(9600);

myswitch.enableReceive(0);

}

void loop() {
if (myswitch.available()){
  int angle = myswitch.getReceivedValue();
  int angle1 = myswitch.getReceivedValue();

  myservo.write(angle);
  delay(200);
  myservo1.write(angle1);
  delay(200);
}
}

How do you distinguish, at the receiver, which value is for which servo?

In the transmitter pott is for the first potentiometer and pott 1 for the second And in the receiver myservo is for the first servo and myservo1 for the second .... I can't separate the signals from each other in the receiver

So, why not label them?

How is that show me an example please