Thank you for both of the responses. I did have the SDA and SCL connected to A4 and A5 so I switched them to the SDA and SCL respectively. I have attached an image of the configuration I now have setup. Below is the response I'm receiving in the Serial Monitor.
Unknow error at address 0x01
Unknow error at address 0x18
Unknow error at address 0x34
Unknow error at address 0x35
No I2C devices found
Scanning...
Unknow error at address 0x01
Unknow error at address 0x02
Unknow error at address 0x03
Unknow error at address 0x04
Unknow error at address 0x05
