Need pointer to RF reciever control of Relay

Projects General Guidance
1

I have Homeassistant platform switch sending a RF load via a Sonoff rf bridge. Below is the console output that i see in sonoff . The part which says "Data" is the payload that is being delivered to RF reciever. The Data is hexadecimal.

17:03:36.098 MQT: tele/rf-bridge/RESULT = {“Time”:“2021-09-10T17:03:36”,“RfReceived”:{“Sync”:7640,“Low”:270,“High”:750,“Data”:“768858”,“RfKey”:“None”}}

With help of this Data load i need to control a relay. I have seen several discussion on use of rc-switch library but not able to use code in any way... can some one help. I am using a Adruino nano with a RF receiver.

2

Can some one help please!!

3

Please take a look at the very first topic telling You how to get the best from this forum.
Your post lacks lots of needed information. Know that every helper is a newbie versus Your project.
The terminology You use makes no sense.

4

Hi, @rajat2485
Welcome to the forum.

Please read the post at the start of any forum , entitled "How to use this Forum".

Thanks.. Tom... :smiley: :+1: :coffee: :australia:

5

This topic was automatically closed 120 days after the last reply. New replies are no longer allowed.