new arduino Micro not working

Hi,

Wired up new micro to drive 2 servos but nothing is happening. The blue lights is on and initially the yellow light was flashing as if it was uploading but now all im getting is the blue light. Under tools I made sure I selected Micro. I measured 5VDC output on the board so that is good. I pushed the reset button as the program was uploading to the board. Nothing has worked.

Any ideas on what the problem is?

Thanks so much

(deleted)

Hi. Actually I thought the micro board itself could power the servos like my uno board did. Is that not possible?
I do have a motor controller that I haven’t used yet. Is that necessary for micro board?
Thanks

(deleted)

Ok. I’ve never had a problem with the uno board powering 3 servos but maybe not with a micro board?

Thanks again