I am just starting a project that involves reading what position a 3 position mechanical switch is in (off, single, burst) and controlling a servo based on that position if a mechanical button (momentary switch) is pressed. off = do nothing... except maybe make sure the servo stays at 0 single = t…

Newbie needs advice on simple project

system October 31, 2012, 2:22am 2

webhansen:
It worked fine, but way too slow.

How are you powering the servo?

Topic		Replies	Views
Controlling a 180 servo speed and position with 3 push buttons Programming	36	8474	May 5, 2021
Servo Control with 3 position dpdt Momentary Switch General Guidance	13	6875	May 5, 2021
Controlling servo position with 2 switches, but servo shakes out of position Programming	3	1259	May 5, 2021
Servo Code Double Check Programming	17	4002	May 5, 2021
"open and close" rotate 180 & stop, rotate to 0 & stop servo project almost done Programming	15	7988	May 5, 2021