"No Response from Arduino" - Error while using CCLoader to Connect to a BLE

Hello everyone,

I am trying to use the Arduino and a BLE module based on HM-11’s CC2541 chip. I am following the following tutorial:

https://blog.raquenaengineering.com/arduino-and-the-myo-armband/

I followed all the steps correctly and my wire connections are pretty good (attached in the post). However, I do not receive a final output. Instead, I get stuck at the response: no response from Arduino.

Has anyone experienced this error or successfully completed this procedure? Any help is appreciated. Thanks. :slight_smile: