NODMCU sketch problem

Projects General Guidance
9

Now is OK?

int Relay1Pin = 4;
int Relay2Pin = 14; // push button is connected
const int button = 0;
int temp = 0;    // temporary variable for reading the button pin status

void setup() {
  Serial.begin(9600);
  pinMode(Relay1Pin, OUTPUT);
  pinMode(Relay2Pin, OUTPUT);
  pinMode(button, INPUT);
  digitalWrite(Relay1Pin, HIGH);
  digitalWrite(Relay2Pin, HIGH);
}

void loop() {
  temp = digitalRead(button);

  if (temp == LOW) {
    Serial.println("Relay1Pin ON");
    digitalWrite(Relay1Pin, LOW);
    delay(10000);
    digitalWrite(Relay1Pin, HIGH);
    Serial.println("Relay1Pin OFF");
    if (digitalRead(Relay1Pin) == HIGH)
    { Serial.println("Relay2Pin ON");
      digitalWrite(Relay2Pin, LOW);
      delay(15000);
      digitalWrite(Relay2Pin, HIGH);
      Serial.println("Relay2Pin OFF");
    }
  }
}