Hey all, So i am a bit new to creating any sort of prototype that isnt directly already on an UNO board. Here is a shot of an LED driver that i have made, however i didnt factor in the feature to program it directly. I want to add a header to allow me to do this, however I have been getting lost wi…

Not sure how to go about programming my dev board.

LarryD October 15, 2017, 4:49am 3

Make sure you add 100nF ceramic decoupling capacitors from VCC pins to GND (as close to the controller as possible).

Topic		Replies	Views
Suggestion to add pin 10 with jumper to ICSP on UNO R4 Suggestions for the Arduino Project	15	6837	May 6, 2021
Using Arduiuno UNO ISCP port 3rd Party Boards	2	1893	May 6, 2021
adding a new chip to uno board 3rd Party Boards	24	6950	May 6, 2021
UNO as ISP? 3rd Party Boards	85	34371	May 6, 2021
Cheapest way to program standalone project 3rd Party Boards	38	14239	May 6, 2021