Hey everyone, I have a couple 8 pin ICs (MSGEQ7s) and I was wondering if I could just solder them directly to a pcb without the need to use a socket that just takes up space. Is this ok or will the heat from the iron damage the IC? In the data sheet there's a "storage temperature" rating that goes …

Not using IC Sockets: sinful?

CrossRoads December 9, 2012, 5:51am 2

You can solder parts right to a board without damaging them.

Topic		Replies	Views
Is this ok? General Electronics	3	897	May 6, 2021
Motor Shield IC Socket Question Frequently-Asked Questions	2	643	May 6, 2021
Prototype PCB board soldering tips needed General Electronics	16	7516	May 6, 2021
Question about DIL socket General Guidance	6	1759	May 5, 2021
IC socket won't hold in breadboard General Electronics	15	11096	May 6, 2021