Hi everyone, I am working with NRF24 connected with Arduino Uno and OPenCM9.04 board as transmitter and receiver respectively or vice versa, using Arduino IDE to upload the code. I had used the same example codes (attached below) on two Arduino Uno and it worked fine. However, now problem is after u…

[image] danaishrathore: int time1; radio.read(&time1, 10); Very strange, I doubt that is from the example code, and it can lead to unexpected behavior. While reading from not owned memory does not hurt on most Arduinos, int time1; time1=millis(); radio.write(&time1, 32); that cod…

NRF24L01 example code with Arduino Uno and OpenCM

Projects Programming

StefanL38 August 22, 2021, 3:07pm 11

As the OPenCM9.04 is a board that has a 32bit ARM Cortex-M3 microcontroller this means you

do

adjust the Arduino-IDE to the OPenCM9.04-Board.

Topic		Replies	Views
nRF24L01 General Guidance	58	14794	May 5, 2021
NRF24L01 - Noob can't get any program to work Networking, Protocols, and Devices	25	3005	May 6, 2021
Communication problem with nRF24L01. Do not send "sent response" Programming	44	6765	May 5, 2021
The NRF24L01 usual topic Networking, Protocols, and Devices	12	1881	May 6, 2021
arduino nrf24l01 Programming	22	949	May 5, 2021

NRF24L01 example code with Arduino Uno and OpenCM

do

Related topics