So, I ordered this opamp called the MCP602 on a recommendation. The idea was to run it on the arduino 0-5v power, amplifying my guitar (AC 300mv max), and then reading the output with the arduino ADC. I posted my circuit image below, as well as the simulation output image. Unfortunately the MCP602…

Op amp woes.

Grumpy_Mike April 2, 2012, 4:30am 12

I assume an oscilloscope?

If so also make sure the input is switched to DC coupling not AC.

Topic		Replies	Views
Wirign of a Op-Amp MCP6002 General Electronics	20	10722	May 6, 2021
Negative voltage in Arduino General Guidance	11	8224	May 5, 2021
Reading output from Op Amp Sensors	20	7508	May 6, 2021
LM386, MIC Help required Audio	6	3938	May 6, 2021
Finished building a signal generator, but one annoying problem exists. General Electronics	7	24884	May 6, 2021