When I supply power at the MEGA it sets two outputs HIGH which start a motor to turn for a scond or so. When I power up the LED 13 blinks two times. Pin is set as output PWM and drive a FET to drive an single motor. As soon as I supply the power the motor starts to turn until the second blink of …

Output high at bootup (need to stay low) Solved

backbone December 1, 2012, 12:16pm 3

Sorry the full code is more then 9500 characters! So I can not put it between code tags!

Paco

Topic		Replies	Views
[SOLVED] pinMode(13,OUTPUT) at boot toggles HIGH Programming	5	3427	May 5, 2021
On boot up, pins go high? Troubleshooting	13	24774	May 6, 2021
I/O pins state on powerup IDE 1.x	8	5020	May 5, 2021
arduino MEGA reset sequence IDE 1.x	5	1472	May 5, 2021
Pin State on Arduino bootup Programming	3	1303	May 5, 2021