peer to peer sB6 digi Wifi configuration

I am having some difficulty getting two S6B Digi Wifi’s to communicate. The program follows. xbeeFE76.available() always equals 0. The program never gets into the if statement.

#include <SoftwareSerial.h>

SoftwareSerial xbee001F(2,3); //rx, tx
SoftwareSerial xbeeFE76(4,5); //rx, tx
int avail;

void setup()
{
// put your setup code here, to run once:
Serial.begin(9600);

xbee001F.begin(9600);
xbeeFE76.begin(9600);
Serial.println(“Finished setup”);
}

void loop()
{
// put your main code here, to run repeatedly:

Serial.println(“Starting loop”);

xbee001F.write(50);
delay(1000);

Serial.print("FE76 available = "); Serial.println(xbeeFE76.available());
Serial.print("001F available = "); Serial.println(xbee001F.available());

Serial.println(“Just before if”);

if (xbeeFE76.available())
{
Serial.println(“In if”);
Serial.write(xbeeFE76.read());
}
delay(3000);
}

001F configuration:

<?xml version="1.0" encoding="UTF-8"?> XB2B-WF-2026.xml 4 1 2 fred 0 0 1 64 258 3 devicecloud.digi.com 208.67.222.222 2.3.4.5 0x20 0x20 0x20 0x20 2616 2616 0.0.0.0 255.255.255.255 1.2.3.4 3 0 0 3 7F3 0 2 1 0 0 0 0 1 0 1 1 1 1 0 0 1 1 7FFF 7FFF 0 0 0 0 28 1 0 1 0 7FFF 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 2710 0 100 1F4 1388 0 2B 64 3E8

F7E6 configuration

<?xml version="1.0" encoding="UTF-8"?> XB2B-WF-2026.xml 4 0 2 fred 0 0 1 64 258 3 devicecloud.digi.com 208.67.222.222 1.2.3.4 0x20 0x20 0x20 0x20 2616 2616 0.0.0.0 255.255.255.255 2.3.4.5 3 0 0 3 7F3 0 2 1 0 0 0 0 1 0 1 1 1 1 0 0 1 1 7FFF 7FFF 0 0 0 0 28 1 0 1 0 7FFF 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 2710 0 100 1F4 1388 0 2B 64 3E8

Attached is a photo of the hardware set up. The sensor in the middle and the LED display are not part of the circuit and are unpowered.