Whenever I insert a wire into an input pin in my Arduino UNO R3 board, no matter what else is going on with the wire, the digital reading fluctuates all over the place. When I disconnect the wire from the pin, the digital reading stays where it was when I took out the wire, meaning if I take out the…

Pin issue on UNO R3

jim-p February 7, 2024, 3:22pm 7

Even if the other side of the wire is connected to GND?

Topic		Replies	Views
UNO reading false high input value Troubleshooting	6	4367	May 6, 2021
Arduino Uno pins acting strangely General Electronics	5	1790	May 6, 2021
High signal with wire disconnected!!? IDE 1.x	6	2259	May 5, 2021
I/O input reading random IDE 1.x	10	3677	May 5, 2021
can't read LOW ? Programming	9	3071	May 5, 2021