Hi All, I've been trying to set up a boarduino. I have chip with the blink program set to pin 1. My problem is however that my board wont work.. I've assembled and reassembled it twice, but the led wont start blinking. When I measure the voltage into the chip, it's at about 4.97 volts. Voltage prio…

Please help me troubleshoot my boarduino

nickgammon April 26, 2012, 11:10am 4

Is that a pull-down resistor on reset? Shouldn't it be pull-up?

Topic		Replies	Views
trying to make a boarduino 3rd Party Boards	4	1446	May 6, 2021
Crystal issue? Development	12	5545	May 6, 2021
Boarduino doesn't start up till 3-5th attempt Troubleshooting	2	665	May 6, 2021
Arduino chip on a breadboard - can't get it to work 3rd Party Boards	10	4331	May 6, 2021
arduino to breadboard General Guidance	6	1708	May 5, 2021