PN532 Tag Emulation

Hi Everyone!

I'm trying to emulate a tag using a NFC Module V3 with a PN532 chip (from Elechouse) in order to read it using an Android phone, and this Arduino code:

#include "SPI.h"
#include "PN532_SPI.h"
#include "emulatetag.h"
#include "NdefMessage.h"

PN532_SPI pn532spi(SPI, 10);
EmulateTag nfc(pn532spi);

uint8_t ndefBuf[120];
NdefMessage message;
int messageSize;

uint8_t uid[4] = { 0x12, 0x34, 0x56, 0x78 };

void setup()
{
  Serial.begin(115200);
  Serial.println("------- Emulate Tag --------");
  
  message = NdefMessage();
  message.addUriRecord("http://www.seeed.com");
  messageSize = message.getEncodedSize();
  if (messageSize > sizeof(ndefBuf)) {
      Serial.println("ndefBuf is too small");
      while (1) { }
  }
  
  Serial.print("Ndef encoded message size: ");
  Serial.println(messageSize);

  message.encode(ndefBuf);
  
  // comment out this command for no ndef message
  nfc.setNdefFile(ndefBuf, messageSize);
  
  // uid must be 3 bytes!
  nfc.setUid(uid);
  
  nfc.init();

  
}

void loop(){
    // uncomment for overriding ndef in case a write to this tag occured
    //nfc.setNdefFile(ndefBuf, messageSize); 
    
    // start emulation (blocks)
    nfc.emulate();

    
    // or start emulation with timeout
    //if(!nfc.emulate(1000)){ // timeout 1 second
    //  Serial.println("timed out");
   // }
    
    // deny writing to the tag
    //nfc.setTagWriteable(false);
    
    if(nfc.writeOccured()){
       Serial.println("\nWrite occured !");
       uint8_t* tag_buf;
       uint16_t length;
       
       nfc.getContent(&tag_buf, &length);
       NdefMessage msg = NdefMessage(tag_buf, length);
       msg.print();
    }

    delay(1000);
}

I have installed the app "NFC Tools" on my phone (S7 Edge) and when I put my phone over the NFC Module, the app shows the message "Tag detected" but all the data is blank, i.e.;

Tag Type: Unkown FeliCa
Serial Number: 00:00:00:00:00:00:00:00
PMm: 0x000000000000000
System Code: 0x0000

What am I missing?

Thanks in advance!

Did you found a solution?
I get the same result.

Edit: it works, you need to set up the right UID for the tag. See SPI card emulation is not working · Issue #88 · Seeed-Studio/PN532 · GitHub