Hi, Will you take a look at this power setup and see if it is OK? I have omitted all wires that are not vcc or ground. Parts: Adafruit Feather 3.3v Is being powered either by USB or 3.7v LIPO battery. It has a JST connector for a battery. In the specifications it says: When the USB power is po…

Power management, Feahter and Pro Mini

Topic		Replies	Views
Power setup of two controllers 3rd Party Boards	1	541	May 6, 2021
Problems with writing to SD card General Electronics	3	635	May 6, 2021
Arduino Pro Mini, Vin and FTDI IDE 1.x	3	2598	May 5, 2021
Powering and programming the Pro Mini? IDE 1.x	7	4268	May 5, 2021
Pro Mini magically turns on 3rd Party Boards	3	532	May 6, 2021