I am new at working with Arduino and I know only the basic about electricity, this is my first project. I am using Arduino Uno with two step motors Nema 17, one works then stops and the other one works and repeat the cycle , with two drivers L298N one for each motor and the power supply is a 12V 10…

Power wire getting hot

jochecho October 23, 2021, 5:24pm 3

Thanks jremington, I just followed the tutorials I found and several of them were using the L298N.

Topic		Replies	Views
Arduino - L298N - Stepper motor Motors, Mechanics, Power and CNC	12	11697	May 6, 2021
The L298P chip and Stepper Motor are Overheating General Guidance	8	5500	May 5, 2021
Arduino, Driver y Motor PAP Español	4	2199	May 6, 2021
l298n heating Motors, Mechanics, Power and CNC	4	700	May 6, 2021
L298H board with Stepper motor Heat problem Motors, Mechanics, Power and CNC	15	8061	May 6, 2021