Problem capturing 433mhz remote codes

Projects General Guidance
8

TomGeorge:
Hi,
Welcome to the forum.

Please read the first post in any forum entitled how to use this forum.
http://forum.arduino.cc/index.php/topic,148850.0.html

Are you sure you remote is 433Mhz?

If you hold them too close you will overload the rather simplistic Rx and not get anything.

Can you post a link to the Tx/Rx units you bought please?

Also, check the Serial.begin( ) statement in the code and make sure you have the serial monitor in the IDE set on the same speed?

Thanks.. Tom.. :slight_smile:

Thanks so much for the tip on reading the first post. I have now done that.

I checked to make sure that both the Serial.begin( ) statement in the code and the Serial Monitor are set to the same value (9600).

I appreciate your help with this.

Thanks,
John