Problem in standalone breadboard Atmega328p

Hi, I having problems with doing a standalone test in Atmega328p: I uploaded the sketch to the 328p in the arduino uno board, but when I put i to the breadboard with the other components (capacitors, crystal) and wire the 5v and GND from uno board to breadboard, its like a short circuit, the leds of uno board went almost off, the resistence between Power and GND is 500ohms. What's going on? I checked wiring almost 5 times and its all ok.

Sorry, I did a wrong wiring between pin 1, I put a power jumper in pin 2 than in pin 1. Blink program its working . Thanks.

Welcome. You are an expert now!

.