problem uploading sketch on arduino nano

Development Tools Uploading
1

:o hello,
i,m a noobie at arduino. i have a arduino nano and uno, i have no problems on uno but i can t upload any sketch on nano. i receive the message :
Arduino: 1.6.13 (Windows 7), Board: "Arduino Nano, ATmega328"

Sketch uses 1,910 bytes (6%) of program storage space. Maximum is 30,720 bytes.
Global variables use 186 bytes (9%) of dynamic memory, leaving 1,862 bytes for local variables. Maximum is 2,048 bytes.
avrdude: ser_open(): can't open device "\.\COM3": The system cannot find the file specified.

Problem uploading to board. See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.

This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences.

oslo i can t select any port under Tools bar.

2

Open the Windows Device Manager and then plug in your Nano. Do you see a new device appear?

3

hi, thanx for your replay, unfortunately i can t see it.

4

A frequent cause of this problem is using a damaged/defective or charge-only USB cable that doesn't have the data lines connected. Verify the USB cable works for data on another device.

5

And if it’s a non genuine NANO it may need the ch340 driver installing.

6

Hi, problem solved. I installed the CH340 driver. thank you