Problem uploading to board.

First time user and i can't get the blink LED to work. Using Windows 10 COM6

Device manager shows Port (COM & LPT) Arduino Uno ( COM6 )

i noticed that when i tried to reset the board, by pressing the reset button, LED 13 didn't blink.

can some one help?

avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x0f avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x0f avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x0f avrdude: stk500_recv(): programmer is not responding avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x0f

avrdude done. Thank you.

Problem uploading to board. See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.

So, did you try the troubleshooting suggestions? If so, what happened (see the forum support section)?

Did you mention which board you're working with?