Problem uploading to board

Development Tools IDE 1.x
1

Arduino: 1.8.5 (Windows Store 1.8.10.0) (Windows 10), Board: "Arduino/Genuino Uno"

Sketch uses 2076 bytes (6%) of program storage space. Maximum is 32256 bytes.
Global variables use 189 bytes (9%) of dynamic memory, leaving 1859 bytes for local variables. Maximum is 2048 bytes.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x8e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x8e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x8e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x8e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x8e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x8e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x8e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x8e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x8e
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x8e
Problem uploading to board. See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.

This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences.

Please tell how to solve this problem

2

You are not the first to have this problem.

Do a search on this forum, and you will be amazed at the others who have encountered this problem much as you like to think you are "special".

.

3

In fact I have the same problem with an Arduino Mega. It was working OK and all of a sudden it started to give the problem. I have no idea how to go around it! Suggestions are very much appreciated.

Regards

4

solution please....

5

read Error uploding blink project - #2 by Ballscrewbob - Installation & Troubleshooting - Arduino Forum

.

6

Send the code and let us know what is going on ??
Are you using the expansive one or the cheapest ??
Have you connected the right port??
Have you connected the right board??
And I have a suggestion if the problem is in compiling the arduino open the device manager then open ports it will show an unknown device. That one is your arduino board but you should define it.
answer those questions then reply us.