Problem with 1.8.5

Hej. When uploading some code which has worked before on earlier versions I get the message "Error compiling for board Arduino/Genuino Uno." The code is P10 of the Arduino Project Book, with a Hbridge, a motor, a pot and two pushbuttons.

One thing that has changed is the port used is com3, earlier it was com7. During the installation a couple of files were reported as wrong. After downloding again and installing I pressed trhe ignore-button for these files. I don^t recall the file names.

I looked fro the driver, and I think it is the right one.

Youes Sverker Almehed

Post full error message.