Hello.. I am facing problem with Interfacing AD7730 with Arduino- ATMEGA328P-AU. The Circuit Diagram, Codes and Serial Output are attached. I am getting output 0 and Ready Pin goes to High after 1st scan in loop. I have cheeked Ready Pulses on LED attached to this Pin. The Codes are as per the Dat…

Problem with Interfacing AD7730

harikeshpatil November 16, 2017, 12:45pm 5

It's not working..

Serial Port Message: wait for RDY signal to goes LOW IN VOID SETUP2

Pl help out

Topic		Replies	Views
AD7730 ADC help Programming	13	8015	May 5, 2021
Arduino and Bridge Transducer (AD7730) Sensors	4	5077	May 6, 2021
AD7730 General Guidance	25	8419	May 5, 2021
SPI communications to ADC Networking, Protocols, and Devices	1	1083	May 6, 2021
Arduino reads AD7780 24bit ADC Networking, Protocols, and Devices	6	5222	May 6, 2021