Hello ! I just get my arduino Uno and rob-09207 kit, I mounted it (Without weld anything) and now I wanted to programm the motor, so I write this in arduino 1.0.1 programm : void setup(){ analogWrite(3,255); analogWrite(5,255); analogWrite(6,255); analogWrite(9,255); pinMode(13,OUTPUT);…

Problem with PWM controll !

Grumpy_Mike November 5, 2012, 8:29pm 8

Well you don't need to set a pin as output if you are going to use it as PWM.
I don't see how turning the on board LED off shows you it is running.

Topic		Replies	Views
PWM ports can't drive motor properly. Possible hardware error? Motors, Mechanics, Power and CNC	13	5824	May 6, 2021
Arduino Uno with H-bridge General Guidance	13	8052	May 5, 2021
Motor works fine on 5V, but not on PWM Motors, Mechanics, Power and CNC	10	4611	May 6, 2021
Motor pins don't work? PWM Motors, Mechanics, Power and CNC	5	1224	May 6, 2021
PWM Deutsch	19	6682	May 6, 2021