Problem with SoundImpactSensorCode

Hello, I am having some problems with my code.
In the buttom of the code in my IF AND state, it says:

exit status 1
expected idemtifier before ‘(’ token

Here is my code:

/*
  SoundSensor

  Turns on and off a light emitting diode(LED) connected to digital pin 13,
  when sound is detected.

  The circuit:
  - LED attached from pin 13 to ground

  - Note: on most Arduinos there is already an LED on the board
    attached to pin 13.

  created 18-05-2018
  by Lysrac <http://steamcommunity.com/id/Lysrac>
  or via Discord <Lysrac#5973>  

  http://www.arduino.cc/
*/

// constants won't change. They're used here to set pin numbers:
const int SEN1 = 9;           // the number of the first sensor pin
const int SEN2 = 10;          // the number of the second sensor pin
const int ledPin2 = 11;        //the number of the second LED pin
const int ledPin =  12;      // the number of the LED pin

// variables will change:
int sen1s = 0;         // variable for reading the sensor status
int sen2s = 0;

void setup() {
  // sets pin 13 as an output to activate internal LED
  pinMode(13, OUTPUT);
  // initialize the LED pins as an output:
  pinMode(ledPin, OUTPUT);
  pinMode(ledPin2, OUTPUT);
  // initialize the pushbutton pin as an input:
  pinMode(SEN1, INPUT);
  pinMode(SEN2, INPUT);
  //sets up serial communication on 9600
  Serial.begin(9600);
}

void loop() {
  // read the state of the pushbutton value:
  sen1s = digitalRead(SEN1);
  sen2s = digitalRead(SEN2);

  // check if the sensor1 is reading. If it is, the sen1s is HIGH:
  if (sen1s == HIGH) {
    // turn LED on:
    digitalWrite(ledPin, HIGH);
  } else {
    // turn LED off:
    digitalWrite(ledPin, LOW);
  }

  // check if the sensor2 is reading. If it is, the sen2s is HIGH:
  if (sen2s == HIGH) {
    // turn LED on:
    digitalWrite(ledPin2, HIGH);
  } else {
    // turn LED off:
    digitalWrite(ledPin2, LOW);
  }

  //Code for checking that both are HIGH at same time
  if (sen1s == HIGH) and (sen2s == HIGH) {
    Serial.println(Sound Detected);
    digitalWrite(13, HIGH);
  } else {
    digitalWrite(13, LOW);
  }
}

Thank you for any help

Try:

if ((sen1s == HIGH) and (sen2s == HIGH)) {

The code works fine now. Thank you so much!