Problema de comunicacion arduino nano- IDE

International Español Hardware
1

Hola amigos, estoy usando por pimera vez un arduino nano. al conectarlo a la pc me reconoce el puerto COM, tengo instalados los driver CH340 , pero cuando le doy cargar me devuelve el siguente error

Arduino: 1.8.19 (Windows Store 1.8.57.0) (Windows 10), Board: "Arduino Nano, ATmega328P"

Sketch uses 444 bytes (1%) of program storage space. Maximum is 30720 bytes.

Global variables use 9 bytes (0%) of dynamic memory, leaving 2039 bytes for local variables. Maximum is 2048 bytes.

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x60

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x60

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x60

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x60

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x60

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x60

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x60

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x60

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x60

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x60

Problem uploading to board.  See https://support.arduino.cc/hc/en-us/sections/360003198300 for suggestions.



This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences.

me pudieran aclarar por que me esta pasando esto?? gracias de antemano

2

Hola

Revisa el cable primero. use solo cable de datos, el cable de carga no funcionará.

3

Si no lo hiciste, debes seleccionar la opción "Atmega328 (old bootloader)" en submenú "Procesador", y por supuesto "Arduino Nano" en submenú "Placa".

También, como dice @b707, puede ser el cable (si lo anterior ya lo hiciste).

Saludos

4

This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.