problems running duinoStamp

Forum 2005-2010 (read only) Hardware Troubleshooting
1

Hi
I've been trying to run a duinoStamp with no luck.

After it dod not work,

First thing I did was to try the atmega 168 from the duinoStamp on my old NG board (which had previously a atmega 8), but it does not work. When atmega 168 is connected, pin 13 turns on and off so it is pre programmed.

Second thing was to try the Atmega 8 in the new duinoStamp board, with no luck again.

I changed the baud rate to 19200 and did all the troubleshooting there is on the arduino.cc site, always with no luck.

hope someone can help me.

thanks

2

If the problem is specific to the duinoStamp, I'd recommend asking the manufacturer of the board for help.

3

I did and they've been very helpful (fundamental logic). I will post the solution to this as soon as I get it.