I have two iDuino boards, one with an Atmega168 the other with Atmega328, and a Uno board (Atmega328)
The IDE is arduino 0022
I've been using the iDuino-168 quite happily, modify the program parameters, re-upload until suddenly Windows declared "USB-device not recognised". Two re-starts of windows failed to get it recognised.
Try again, using the iDuino328 - device recognised, then in IDE changed the board to (guessed at) Arduino Duemilanove ... w/Atmega328, and compiled it. Check, yes it's on com5 still. Upload. It has been uploading the 5494 bytes program all the while I have been typing this letter - about 10-minutes.
On the other hand, the same program compiled for the Uno, when plugged into the Uno on com3, uploads in a few seconds.
Can any of you give me some suggestions, please?
Regards,
Geoff