Programming AirCore Gauge

Hello,

I have read through the reference, and library, and have not figured out exactly how to interface an aircore driver with the SPI from the arduino.

I am using the CS4192XDWF16 AirCore driver (whos datasheet can be found here CS4192 datasheet & application notes - Datasheet Archive) and have the entire deisgn up on a bread board for testing. I am trying to run the OSEPP Pro Mini to interface with the driver.


I feel that it must be a programming error with how I am sending the data which is why i get not response from the gauge.

I have attatched my very simple, basic, sketch and i hope someone can guide me.

I apologize if this is posted in the wrong forum.

AirGaugeDriver.ino (333 Bytes)

TTT

Any luck on this?