Hello, I want to collect data from the accelerometer of the Arduino. I can easily collect the data from my sensor. Due to my project, I dont want to get the power supply from my pc, I want to use powerbank for the power supply.
I had already run the WIFININA and SimpleWebServer codes but when I plug the arduino to the powerbank, the arduino ide software got error about "could not find the port" what should i do ?
Your 2 other topics on the same subject have been deleted
Other post/duplicate DELETED
Please do NOT cross post / duplicate as it wastes peoples time and efforts to have more than one post for a single topic.
Could you also take a few moments to Learn How To Use The Forum.
Other general help and troubleshooting advice can be found here.
It will help you get the best out of the forum in the future.
Please reflect on the proper way to use this forum during your short suspension from it
Enlarge the information. What port is not found? Disconnecting USB cuts a port off.
Please post a least a block diagram showing power and signals.
Read about hou to use the forum.
Post your code using 'code tags' as described.
Be specific when describing what does not work.
Where do you see the error message? On your PC?
When unplugged it is not connected.
You would need to use your browser to log onto the wifi of the 33IoT.
Unless there is part of the IDE that does WiFi
This topic was automatically closed 120 days after the last reply. New replies are no longer allowed.