I have few circuits lying around and would like to setup them up on some standoffs. The problem is they're all on prototype board that was cut from a bigger piece so no M3 holes. Are there any standoffs for a standard prototype board hole? Thanks

Prototype board standoffs

system April 19, 2012, 3:38pm 6

I recommend the mechanical engineer's best friend:

Just about any and all standoffs you could possibly want. Very fast shipping as well, usually out the door within the hour.

Topic		Replies	Views
Where to buy hardware to mount prototype boards General Electronics	8	899	May 6, 2021
Mount Power Supply Board to Protoboard General Guidance	5	1633	May 5, 2021
Nuts & Bolts Bar Sport	6	2612	May 6, 2021
Holey Board - GHI Electronics General Guidance	6	1247	May 5, 2021
Spacer / Standoff Mounting Suggestions General Guidance	8	19525	May 5, 2021