Push button control over Stepper motor TB6600

[TomGeorge]

Hi,

@peterjin

My requirement is to control a stepper motor to turn CW or CCW using a push button. So that, when the push button is pressed, the stepper motor will turn CW or CCW until the button is released. Then after the stepper motor was move to the required position,

Which do you want;

1. The stepper to stop when you release the button?
   OR
2. The stepper to continue to the required position after you have released the button?
   OR
3. The stepper to move to the required position and stop even if the button is still pressed?
   OR
4. Cases 2) and 3)?

What are you using to drive the stepper motor?
Your code at the moment will make the stepper rotate continuously.

Have you tried it on your hardware?

Thanks... Tom...