Push Button State Change (Multiple Conditions)

Projects Programming
13

Okay, took a quick visit to https://wokwi.com

const int buttonPin = 3;    // the number of the pushbutton pin
const int ledPin = 13;      // the number of the LED pin

const int powerPin = 4;    // the number of the input power pin

// Variables will change:
int ledState = HIGH;        // the current state of the output pin
int buttonState;            // the current reading from the input pin
int lastButtonState = LOW;  // the previous reading from the input pin

int machineState;           // current reading from the power pin
int lastmachineState;       // previous readin from the power pin


// the following variables are long's because the time, measured in miliseconds,
// will quickly become a bigger number than can be stored in an int.
unsigned long lastDebounceTime = 0;  // the last time the output pin was toggled
unsigned long debounceDelay = 50;    // the debounce time; increase if the output flickers

unsigned long lastDebounceTime1 = 0;  // the last time the output pin was toggled
unsigned long debounceDelay1 = 50;    // the debounce time; increase if the output flickers

byte pushCount = 0;

void setup()
{
  Serial.begin(9600);
  pinMode(buttonPin, INPUT_PULLUP);
  pinMode(ledPin, OUTPUT);

  // set initial LED state
  digitalWrite(ledPin, ledState);
  Serial.println("Ready");
}

void loop()
{
  // read the state of the switch into a local variable:
  int reading = digitalRead(buttonPin);
  int mreading = digitalRead(powerPin);
  // check to see if you just pressed the button
  // (i.e. the input went from LOW to HIGH),  and you've waited
  // long enough since the last press to ignore any noise:
  // If the switch changed, due to noise or pressing:


  if (mreading != lastmachineState) {
    lastDebounceTime1 = millis();
  }

  if ((millis() - lastDebounceTime1) > debounceDelay1) {
    // whatever the reading is at, it's been there for longer
    // than the debounce delay, so take it as the actual current state:

    if ( mreading != machineState ) {
      machineState = mreading;
      if (machineState == HIGH) {
        Serial.println("MACHINE ON");
      }
      else {
        Serial.println("MACHINE OFF");
      }
    }
  }

  // save the reading.  Next time through the loop,
  // it'll be the lastButtonState:
  lastmachineState = mreading;

  if ( lastmachineState == LOW ) {
    return; // nothing more to do if machine is OFF
  }

  if (reading != lastButtonState) {
    // reset the debouncing timer
    lastDebounceTime = millis();
  }

  if ((millis() - lastDebounceTime) > debounceDelay) {
    // whatever the reading is at, it's been there for longer
    // than the debounce delay, so take it as the actual current state:

    if (reading != buttonState) {
      buttonState = reading;
      if ( buttonState == LOW) {
        ledState = !ledState;
        digitalWrite(ledPin, ledState);
        if (ledState) {
          Serial.println("LED ON");
        }
        else {
          Serial.println("LED OFF");
        }
      }
    }
  }
  // save the reading.  Next time through the loop,
  // it'll be the lastButtonState:
  lastButtonState = reading;
}