Okay, cool, that makes more sense 
Again, if the pot on my servo is left at 1503 (or just not exactly on the middle of it's range), and I put in 1500 to stop it, will the servo keep doling out a little bit of power to try reaching the home value?
Edit:
Just did a small test using writeMicroseconds.
The servo seems to stand still at serv.writeMicroseconds(1160);
Anything below and it turns ccw, anything above and it turns cw.
?? I'm pretty sure I took the pot and turned it each way to find where the limits were, and then left it in the middle. That number seems pretty far off x.x
/edit
Another edit:
I read somewhere about unsoldering the pot and bridging a connection with a resistor, but I can't seem to find any more details than that x.x