Raspberry Pi Screw Shield

Community Products and Services
1

I've come up with a Pi Screw Shield to bring the 40 terminals out to 3.5mm pitch screw terminals.
It can be plugged directly onto a Pi (female header option pictured) or it can be connected via ribbon cable (male header option). 4 pairs each of A/GND and B/GND can be used to connect to Pi power/gnd pins.
(Pi pinout varies by model, so no connections to pins were made for these.)
Assembled board $30. USPS and paypal fee added. Worldwide shipping available.
PM me or e-mail to robert@crossroadsfencing.com
Cross Roads Electronics

1072×1891 299 KB

944×997 138 KB

2

Looks almost exactly like the new Mega screw shield! :wink:

3

Isaac96:
Looks almost exactly like the new Mega screw shield! :wink:

You should never change too much on a good design :wink:

4

robtillaart:
You should never change too much on a good design :wink:

Not a good design-a great one.

5

Yes - same PCB, flipped over & populated from the other side. A few more pins on the header, 40 vs 36.