RASWIK arduino board problems

Development Tools IDE 1.x
1

Hi All,

I am a beginner when it comes to Arduino so I'll try my best to explain the issues.

I started with a Raspberry PI 3 and a RASWIK kit (from maplins), firstly I had problems with the preconfigured software and began to realise that not only was the boot loader Depreciated that the kit was not even supported anymore.

So I booted up Debian and downloaded the RASWIK software, it opens but when I try to connect the XINO RF with the slice of radio connected to the paspberry PI the software freezes. I am a little out of my depth with this and there are no forums or help sections available on the net. Can anyone help!

Thanks in advance

2

It is NOT an "Arduino"

You are going to be much better off in the Raspberry Pi forums than on here as these forums tend to deal with primarily "ARDUINO"